SX Bass Project Part 1 - introduction

Given the current economic times, I have decided to take on an economical project. I have fantasized about getting a big bonus and paying off credit cards and buying a new Nordstrand vP, which I hope to check out at NAMM next weekend. But... OK. Back to reality.

Here is the bass as it arrived. Or rather, as it looked a few hours after it arrived. The sunburst is much nicer than what is seen on the Rondo site. I think I'll leave it.


When I did the plugged-in out-of-box test, I noticed the bass side pickup was weak and hollow - and sensitive to touch noises like tapping the body. At first I thought there was a short between coils and magnet, but then I realized there must be movement allowed between the magnet and coil - thus creating a microphone. Sure enough, the magnet had popped off the back of the pickup. Oh well. Wasn't planning to keep the stock PUs.


Anyway, here is a short list of the modifications planned (at the moment):
1. replace pickguard w/ black - see part 2
2. re-shape the headstock - see part 3
3. replace the pickups with Dimarzio DP122
4. replace the electronics (sans tone?)

Aquarium table

This table or similar to be built early 2010.

The Village Green - Not a photo of a project...

But rather a list of links about the Village Green in Baldwin Hills, Los Angeles, CA.

Apartment Therapy

Wiki page

LA Times Article

Official HOA link

Hardboard - not for gluing

After a year of using my narrow bedside table, the glued joints failed during a quarrel between our cat and dog. I was surprised to find the surface of the hardboard gave rather than the laser-cut edges.

1x12 speaker cabinet

Built in 2005 to augment my Aguilar GS 112. I used a Carvin PS12 speaker. Sounds great. Cabinet hardware (corners, handle, port holes, and jack plate) are from Penn Fabrication - same as Aguilar. The triangle pattern mesh grille was laser cut from PETG while I was working at UCLA. PETG is resilient to bending - not brittle like Plexiglas.